1/27/2024 0 Comments Cat 289d data link error![]() ![]() ![]() It does have an inclinometer in the implement carrier. Bad SIS, bad SIS.įinally, I've replaced the body ECM, engine ECM, and DEF ECM and need to set the hours to be accurate for the machine, but I can't find where to do that in ET.īoy, I've combed through UENR3423 and can't find anything about 5435. A search in SIS for inclinometer and inclin, comes up with nothing, predictably. ![]() I've completed the Valve Min & Max calibrations for lift and tilt, but of course this isn't to do with the inclinometer, and I can't find a calibration for it in ET. Well this is in SIS, but it says to do the calibration - which eh, does not exist in the book. The third error is "Loader Bucket Inclinometer Sensor : Out of Calibration" #MID 039 - CID 3700 - FMI 13. There's no such thing as an error 5435 in SIS, and why would it only happen after the machine's been running for a good while? (calibrations) I would think this is warning me that DEF fluid is low, but it's about 1/4 on the gauge. It shows after I've been idling the engine on high for at least 45 minutes. The second is a scary red alert Reagent Low #5435-1. (No error#) But this happens when it's 45* outside and 55* outside, and even comes when the machine is warmed up and I turn it off/on and the coolant is 172*! I thought maybe this is a setting in ET where derate for cold is set way too high, but I can't find it. The first says it's derating due to the cold. It was a total burnout and I'm pretty happy with the result.īut it's giving three errors which are not in SIS. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |